Interested to Buy Any Domain ? << Click Here >> for more details...
why we do not switched on capicitor panel with DG Supply
- 3 Answers
- 6518 Views
- DLF, I also Faced
- E-Mail Answers
Answer Posted / hitesh
when Dg set is on, reactive power needed in system is
controlled by the avr system.
when we connect external capaitors then the system will run
on leading power factor hence also reducing active power
supply of alternator.
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
What shall be the secondary output voltage if the primary winding of a 220/6V, 50 Hz transformer is energized by an 110V, 60 Hz supply?
State the frequency for rc phase shift oscillator?
State thevenin’s theorem?
what is servo motor and how to work it.
why in an industry; machine having rated 200 h.p stopped after power factor is maintained above 0.97 lag by control panel in view-of energy saving
High voltage test procedure of in swgr board. why should measure millivolt drop on testing time?
i need mat lab program to find out the transmission line losses,regulation and losses
63MVA,220KV/6.9KV Transformer LV side neutral is connected to Earth pit through NGR. Whether this earth pit required to connect with near by below grouding earth mat or it is to be kept separate?
Please clarify 1. Icw: rated short circuit working withstand capacity 2. Icu: Rated ultimate breaking capacity 3. Ics: Rated service short circut withstand capacity 4. other specification of ACB
I Need standard operation procedure(SOP)for 500kva Oil type transformer oil filtration & Procedure for IR value checking.
what are the different kind of cables used for transmissions?
how withstand of hi-pot test outputs of transformer wire 2.5mm
what is the difference between switch yard to residential area.and how much required it.
what is the basic construction diffrance between servo motor ans sqiralcage induction motor
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
