Interested to Buy Any Domain ? << Click Here >> for more details...
how manys ways dp transmitter can be calibrated having
range of -150 to 400mmwc,what side pressure u will apply?
- 3 Answers
- 8186 Views
- I also Faced
- E-Mail Answers
Answer Posted / jigar anadkat
You Can Calibrate in Two different Ways:
1) By applying normal pressure according to the range i.e.
(-150) mmwc with vacuum pump and observe 4 mA and keeping
this pressure on LP side apply 400 mmwc in HP side and
observe 20 mA (in steps).
2) Apply 150 mmwc on LP side and observe 4 ma [HP-LP=0-150
= (-150 )], then keep LP side open 0 mmwc and create
550mmwc (400+150) span by applying pressure on HP side and
observe 20 mA (in steps). If no pressure on both the side
your TX will give o/p = 8.36 mA
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
control panel design guidelines
components of control circuit belongs to control valve
why we use cascade control and feed forward control in 3 element drum level control measurement of steam drum .what is cascade and feed forward control system ?give example .
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
what is SIL 1 2 3
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
WHAT IS THE DIFF. BETWEEN SKIN TEMPERATURE AND PASSES TEMPERATURE..?
I want to know about DDCMIS in detail ? please explain it. Also give name of reference books in which it is explained in detail in very simple manner.
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
what is interface level and how it is calibrate?
What is the use of control cable?
what is exact time to study dcs and plc cources
HI friends.I am Surya a BTech in Electronics and Instrumentation Engineering.I am going to appear Relince Industries Ltd all India writen test very soon. so plz help me by sendind the probable questions about my subject.My mail ID is surya.barik@gmail.com.
Draw block digram for well head from well to shipping pump?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
