I have two power supply.a)govt. power b)Captive power.3
phase load connected inside factory.when source change govt.
source to captive some motor rotate reverse. Is phase
sequence changes when if off & on?If I off generator & on it
again is it possible to get changed phase sequence??
- 4 Answers
- 5605 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / ganesh.a
no phase change will accur if u turn it off nad on again.check
the polarity of captive power
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what happened when we supply a dc current in dc motor?? can it worked properly?
What are marginally stable systems?
what is the difference between gas group b and gas group c electrical equipment construction wise?
how can we save enegry by using VFD for Resiprocating Air compressor which is having more unloading running hours
Draw the DOL starter and star delta starter drawing?
what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks
SUTIABLE FOR ohm's law super conductor
What fomula is used to calculate: 1. rated frequency withstand voltage, and 2. rated lightning impulse withstand voltage.
can u give me a brief idea about power line carrier communication ??
In Designing the rating & accessories of a MCCB how to choose the type of releases..means what is the basis for selecting, thermal magnetic, electromagnetic & microprocessr based releases
Benifits of 3ph 4 wire metering over 3ph 3 wire
What happen when change order of CT in GIS feeder?
Why dry type cast resin transformers tap link blast in HV side while power shut down times on load?
Brushes are placed at magnetically neutral axis,when brushes reach that point,the armature conductor gets shorted,but it can be seen that the dc supply is also shorted,wont that get damage? help me plz
Alternator rotor earth fault relay circuit
