what is different between buchhoz relay and pressure relife devices in transformer
- 2 Answers
- 4604 Views
- Spanco, I also Faced
- E-Mail Answers
Answer Posted / abhishek goyal
when the short ckt or any other fault happening into the
transformer it will detected by the buchhloz relay (gas will
accumulate into the relay). if pressure into the tank is
above the set point of PRD/PRV it will activate. both are
safety device one can sense the gas other one can sense the
pressure.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How much pf maintan in dg set in 6o% load,when Dg runnig Neutaal Earthing removed what happen.
What will happen if i replace a inductive proximity switch with photo sensor in a machine?
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
Dg pf .71 i am improve pf 0.80 what capacitor connected in dg how?
what is the benefit of floating our DC source? if i have two floating DC source of which 1 has a ref voltage of -21VDC and the other of -18VDC. can it be connected in parallel to share a common ref voltage? if not, how do i make both sources to be of common ref voltage? tks
what is alluminium arm in ab conductors
What is resonant peak?
detailed procedure how we calculate cost for pcc m10 and rcc m20 including centering and labour excluding steel/ iron
what is reactive power?, why its measured in VA ? is it transient behavior of system?
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
how to Select Lighting arrester? What r the parameters to be considered for the selection of Lighting arrester ?
single phase power supply give to separate one steel coup with water, what reaction create
Did RMU have ct and pt ?
Where voltage are high and current to be interrupted is low the breaker preferred is:
How to protect a Dosing pumps/any sensitive equipment (single phase) from surge protection inside a food factory.
