Interested to Buy Any Domain ? << Click Here >> for more details...
Why CT's shall not be kept open?
- 5 Answers
- 8784 Views
- ABC, Qatar Gas, TIPL, I also Faced
- E-Mail Answers
Answer Posted / abhishek goyal
CT always connecting into the series position. If we have
some work on the Meter, we need to short the CT terminal. If
CT in open condition (it can't connected to the meter)its
step down the current in terms of 300/5AMP (for example).
After few second or minute it will drawn the more current at
infinite level at that time CT temperature also increase. If
we can't short the CT it will make big blast or sever
damage.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how to design the heater in temperature control unit to heat 50KL of water?
how to choose cable size with respect to load? how to convert cable size in mm2 to sq.mm?
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
1.ZEBRA conductor(large size) 2.KUNDHA conductor( small size ) 3.panther conductor(very small ) 4.lepard conductor (very very small)
difine electrical ballast in HPSVL
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
1.WHAT IS A SMART CAPABLE DB ( DISTRIBUTION BOX) ? 2. HOW TO DECIDE THE TYPE OF DB TO BE USED ( RECESSED/ PLUG TYPE/ SMART ETC ETC? 3. WHAT IS MILLENEUM BUS BAR USED IN DB? 4.DIFFERENTIATE MCCB AND MCB.
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
Why line VTG = √3 phase VTG in star? How?
is IS says that neutral should be brought to switch box. and this one is a recomended practice
What will happen if a dc source is given to a tubelight. Will it work or wont it work....
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?
What is knee point voltage of transformer?
What is hipot test procedure?
what is earthing.how we make it,describe briefly.
