Interested to Buy Any Domain ? << Click Here >> for more details...
How to work star delts method in the case of single phase
motor?
- 4 Answers
- 8825 Views
- Siemens, I also Faced
- E-Mail Answers
Answer Posted / guest
Star-Delta motor starting method is for reducing the
starting current by dividing line current with 3 square
that is considered in 3 phase only, and also most of single
phase motors are small motor having small starting current
so it is no point to reduce the starting current.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What happen when change order of CT in GIS feeder?
I want to put this query to SENIOR & EXPERIENCED ELECTRICAL ENGINEERS. 1)I want to know about the control circuit diagrams for control panels. I found it difficult to understand. Is there ant booklet through which we can learn the circuit diagrams? 2)I want to learn about conduiting, laying cables, preparing cable schedules and various techniques which is the part of building infrastucture(construction field). I don't have any experience in this area. I have experience in control panels only. that's why i am not getting any opening in building infrastucture (construction field).Can I get the job in this field as Trainee Engineer? How to enter this field? I need job in PUNE
why magnet has north and south poles only why not east and west and why we are considering as north and south poles? why cant we consider as east and west?
What are the different power system losses and how can it be eliminated?
what is self capacitance of inductor
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
how does a submersible pump work..?
How can we calculate the motor frame sizes?
Why the output of OP-AMP is always less than Vcc?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What is resonant peak?
th how could we differentiate between armoured copper and armoured aluminium cable what is the basic application? why we prefer the armoured copper as compared to armoured aluminium.
How to calculate impedance volt in Transformer?
How to size fuse? How to size MCB?
What is the meaning of HT Trivector Meter ?
