WHY WE GENERATE 3 PHASE POWER ONLY AND NOT 4 OR 5 OR 6
PHASE??? PLS REPLY.
Answer Posted / ziyad
there is no engineering reason for that.
the reason is economical.
since they start generating by three phase and the following
designs was based on the first models, and it is difficult
to change the system that already exist so they continue to
design three phase generators and transmission systems.
Is This Answer Correct ? | 5 Yes | 6 No |
Post New Answer View All Answers
How to resolve if Diesel generator stop while running ?
what is the string efficiency
What is the effect on power factor, shown by a trivector meter; incase of reverse phase sequence. If the power factor of a system is lag what meter will show in case of reverse phase sequence connected to the meter. and What in case of lead.
What is the angle of inclination for the oil connection from transformer conservator to Bucholz relay and why?
what is relation between ct and pt ratio with multiplication factor of a energy meter? is there any other factor on which multification factor depend?
nwhat are the main Components of servo motor?
What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?
How to Calculate The Neutral Earth flat design calculation for the Synchronised generator (Gen 1-650Kva, Gen 2-725Kva
What is minimum phase system?
How you calculate the repturing capacity of a HRC fuse
Please tell me in DETAIL about the following 3 types of fuses or recommend me a good power system protection book or a website link ? 1.Dropout Fuse 2.Striker Fuse 3.Empulsive fuse (not sure if its impulsive or explosion fuse , sorry)
As we know induction squirrel cage motor torque Directly praprortinal to applied voltage in star connection & delta also. If I connect 55KW Motor to DOL starter in load condition does motor withstand the load & what will be the current withdrawn ? motor will not fail ?
Why compensation is necessary in feedback control system?
what is the current setting for different relay protection for transformer .
How to find out damper winding failure for synchronous machine?