Interested to Buy Any Domain ? << Click Here >> for more details...
there is a power transformer 66/11kV in delta-delta
connection has 5 feeder coming out from the secondary side.
One of the feeder in it normally loaded (loaded than other
feeder)and this feeder usually trips with double OCR causing
the bank transformer to trip. Now if the load of this feeder
is put on other transformer then that no problems occurs on
that transformer or the load. However normally all the
test(IR, PI, short ckt, open ckt,grounding test and other )
has been conducted for this but evertything transformer.....
I am not geting what is the actual problem...
- 2 Answers
- 5349 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
More data is required for analysis.If the transformers are
of same capacity and relays are identical ,interchange the
relays of transformer banks and watch.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what are the principles of a booster converter?
What is industrial plc
Mention how NPN and PNP transistor works?
What is resolver and glass scale in CNC how they work?
how you will decide the distance between the power transformer and its fencing
in india per day how much power is generated including all power station
what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem
STATE USE OF ARC RUNNERS & SPLITTERS ?
Why does increasing the magnetic flux in the main field of a d.c motor cause the armature current to reduce??
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
How can i calculate the Breaking capacity of molded case circuit breaker, is the breaking capacity of CB for Diesel generator shall be less than grid supply's breaker ?
What's the difference between non break power supply and non break non short break power supply
What are the characteristics of negative feedback?
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
What is the difference b/w fanuc alpha series 16i and 18i controller. what is stand for i
