Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / abhishek
actually the voltage control is reactive power control. All loads are consume only the reactive power so the reactive
power limits in power system is voileted so the system
stability is inadequate.
FOR MORE USE PRABHA S. KUNDUR
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
what is the safety points of vaccum circuit breaker.
Can we use BS 6651 and BS EN 62305 standards for computer room lightning ptotection in substation?
why the perameters of secondary circuit are more important then that of the primary circuit of induction motor?
what is the use of permanent magnet generator in exciter
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
Are Refrigerators & Deep Freezers the Inductive load ? How to calculate the Power Factor & hence the Output Power for them ?
What is value of earth resistance required for substation and equipment earthing and what are the reference guidelines
when qty of cable being purchased is not sufficient according to the standard,what should the inspector do to ensure its quality according to the standard?
What is the ratio of Booster transformer?
What is power distribution criteria for converting single phase unbalanced residential load to 3 phase star connected balance system. Does total KW converted to 3 Phase. Means Divided by root 3.
Explain thin film resistors and wire-wound resistors
why dimmerstate always connected in star connection? what will happen if it connected in delta?
What is instrumental error?
1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?
What tests should i carry over on a newly rewinded DC Generator with voltage rating of 38 volts and current rating of 350 amps, to certify that the machine is OK?
