in mosfet we have different types like enhancement and
depletion.but why do we preffer enhancement over dpletion
Answer Posted / deepak singh
Hi,
Enhancement type --> normally OFF .that means we have to
apply Gate voltage to ON the circuit .
depletion type---> normally ON.we have to apply gate voltage
to switch it off.
Mosfet are normally used in digital circuit .so we need a
device which is normally OFF.
So we prefer Enhancemnt type over depletion type.
Is This Answer Correct ? | 14 Yes | 1 No |
Post New Answer View All Answers
what must be the kind of test on innovatronix
Explain why is the diffusion technique of formation of resistor most widely used?
Can a gas be used for conducting current?
Define what is transistor biasing?
Indicate the various quantities that can be measured with a multimeter.
1.Explain 3D radar. 2.Method of mobile signal jamming. 3.Frequency hopping spread spectrum. 4.How does op-amp works in common mode? 5.Which flip flop is known as universal flip flop and why?
What is fm.
Define fbus protocol?
why is the diffusion technique of formation of resistor most widely used?
Why cannot we use leds for rectification purpose?
8. How many E1s are supported by one E1 card in BTS
Explain Power Control.
What is the significance of the bandwidth of an amplifier?
What is the approximate cost of the corrosion penetration monitoring system(cpmp)?
What is a full-adder?