Why HT cable have only 3 core ?
Answer Posted / superjyoti
HT cables are rated at 1000v to 11kv.This is the range of
transmission voltage.In normal transmission line three
conductor are required.Electrical power is generated at
power plant(11kv normally),then stepped up by transformers
to transmit power to far substation.The secondary winding
of these transformers are in delta connection.
Whereas LT cables are rated up to 1000kv used for
distribution purpose.they are generally of 3.5 core,4 core
etc.three are for phase one for neutral.In the distribution
transformer secondary winding is generally star
connected.so we get 3 core 4 wire o/p(1 wire for neutral)
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
EXPLAIN USE OF ROCKING ARRANGEMENT IN ELECTRIC HEATING?
what is transformor oil gread
how to read idmt curva
Can 4pole (3 phase+neautral )RCCB proper functioning in only 3 phase load (no neautral, no Earth) ?
which of the following elements is not present in stainless steel
How to calculat the ratio of HT\LT in energy meter
What is the effect of atmospheric pressure & Temp; on efficiency of motor? Why NGR(Neutral Grounding Resistor) is used in 132/11 KV Transformer & how? What is the use of Auto T/F in Grid Station?
We have 5 Distribution sections with variable loads&We have 3 Gensets(500kva,380kva&250kva) our total load is between 400kva to 600kva. so how could we connect 3gensets.
a 100mva,400/200v transformer has leakage impdce of 10% draws a steady state line currentof---------------
What is ideal IR values for ground and neutral.
how to get electrical supervisour certificate in gujarat
What are your future plans for the company if permanently employed?
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
What are the disadvantages of thermal power plant?
Why we make earth connection with Transformer Body and What will be the minimum size of copper wire as per code with respect to KVA rating of Transformer?