Interested to Buy Any Domain ? << Click Here >> for more details...
can u tell the difference between star-star transformer and
delta to delta transformer.
- 3 Answers
- 5796 Views
- Videocon, I also Faced
- E-Mail Answers
Answer Posted / shahbaz shaikh
in star star transformer the primary winding of transformer
there is phase voltage is same as the line voltage but in
delta phase voltage is diff as compair to line voltage.
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
how to test the turn ratio of 3 phase transformer using volt meter shoe the curcit diagram.
Difference of induction motor & servo motor ??
What is the effect of pd controller on system performance?
what is the difference between active power and reactive power and apparant power in practical as well as theoritical
a 100mva,400/200v transformer has leakage impdce of 10% draws a steady state line currentof---------------
what is meant by 3rd hormonics ?
Why auxiliary transformers are not connected in parallel in primary stations?
Please explain me about Relay curves and their sources to read ?
what type of questions are asked and howmwny questions belong this catagory?
how we provide neutral earth on synchronising panel as per electrical standards?
How to test Alternator stability test for REF relay
what are the advantages and disadvantages of speed control of 3 phase induction motor by varying frequency explain with drawing
Is MEN and RCD related to each other ?? IF yes then how??
we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer
In our factory so many iron pillors are exists for supporting the shed/Hangar. If do more no of earthings at one piller instead of doing more earth pits in many locations and running earth strip around the hanger, I can save the money. Please suggest this method is acceptable as per Is specifications though the Earth resitance of the farthest piller is with in the limits as per IS specifications.
