Interested to Buy Any Domain ? << Click Here >> for more details...
How to calculate the quantity of water in cement mortar eg.
CM 1:3?
- 3 Answers
- 7471 Views
- I also Faced
- E-Mail Answers
Answer Posted / ajay saini
Actually it depends upon the weather condition.The amount of water can change according to the weather.1 liter water is sufficient for 10 kg of cement.With the Aggregate the amount of water will be increased.
| Is This Answer Correct ? | 2 Yes | 9 No |
Post New Answer View All Answers
What is the density of DLC & PQC and how it is differ from normal concrete?
What is thumb rule in quantity and cost estimation of a residential building?
I am practising engineer. I am searching for tutorial of RCC T Girder design Example in staad pro.Do anybody has this?please help
Why concrete barriers have curved surface profiles?
As per Kandal suggestions, we have implemented rolling starts on 140 (+/- 5) degrees and we kept 3 rollars to complete the rolling before falling 125 degrees and the Aggregate AIV is below 22. But When the DBM bed is being rolled 3rd high viabration, (Before 1 plain & low ,2 high Viabrations), the aggregate is getting sharp edge agg. projections are damaged. As the literature is said that, the VG-30 Grade having better control the temp. susceptibility than Penetration grade. if so we could not get this problem at site. But we are facing on site. let me know.
what is right & short method of measurement of slab&beam
Draw a neat sketch showing the 'throat' of a welding in a plate girder ?
At what point does a circle start losing area when being flattened?
How much wastages taken in 1. cement 2. steel 3. fine aggregate 4. coarse aggregates (10mm, 20 mm)
A sieve analysis results in 100% retained in no. 50 Sieve, the fm is?
whaat is blister in box girder bridge and what is its function..
what is the cost differene of a same structure when it is constructed with brick masonary, and when it is constructed with concrete as a frame structure.????????
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
Used Cement & Sand in 1 Square Meter or 1 Square Feet For Brick Work 0.115mm ? (1:4) (1:6)
Explain soil analysis?
