Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / piyush rana
% Impedance is the primary voltage at which the rated
current flows from short circuited secondary winding.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
In radial network the source is fed from 1 end both ends at central
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
What does ampere turns shows?
What happens to a motor if it is connected in Delta connection
Difference between ac parallel circuit and ac series circuit?
In single phase capacitor motor, if the motor rotate reverse direction then how much power will be consumed by the motor and why?
what is the reqirred voltage in HT motor to get full RPM on no load test?
how to select battery for 15 KVA UPS with formula
sir i want previous entrance exam papers for written test
What is Percentage impedence of a transformer? why it is expressed at a percentage? what is the importance of percentage impedence in case of a transformer?
What are the advantages of nichols chart?
Why and when NGR panel required. Is it necessary to design a NGR panel for a 6.6kV Alternator paralleling with Grid????
do we use links in a dc circuit?if so what s its use in it?
The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.
why the check zone and main zone are used for Busbar Protn. scheem?
