Answer Posted / guest
TO KNOW THE COOLING CAPACITY AND TO KNOW THE COPPER LOSSES
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Why L.T.Cable voltage rating is 1.1kV,where as system voltage is 0.415kV?
mostly the questions were from machines... d.c. machines, transformer, synchronous and induction all theory paper........ few from power system... but the level of paper was easy.....
How is the resonant peak, resonant frequency, and bandwidth determined from nichols chart?
what is dc mator?types of dc motor?losses in dc motor?what is the mechanical,electrical and commercial efficiency of a dc motor?
pls tell what are doing the three phase motor star and delta connetion with circuit diagram and control wiring .
What should be the amps for a MV fuses for transformer 630kVA 20(10)/0.4 kV
What is the principal of motor?
what is the string efficiency
what questions are asked in the interview for the post of an electrical maintenance engineer in FMCG companies?
Why Stabilising Resistor used in REF circuit ?
What is the Difference between Ac Drives and Dc Drives? According to application, speed, Torque, cost, Reliability, Construction, Motor etc... Thankyou !!!
orifice sizing how done, checking & selection
Whar is the KvA rating of 33Kv substation & actual kv rating of power generaating station.
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
On a 3 winding transformer YNynd11, how do you apply REF protection to the Delta tertiary winding that is supplying auxiliaries to a substation?
