why Transformer and DG rating capacity is in KVA
- 4 Answers
- 10134 Views
- ACC, I also Faced
- E-Mail Answers
Answer Posted / n rajesh(zuari)
Transformer and generators rating in KVA due to this is not
depended on power factor.Motors current depended on copper
losses and voltage depended on iron losses so, this is
depend on power factor.
| Is This Answer Correct ? | 11 Yes | 2 No |
Post New Answer View All Answers
defult setting in p220 micom motor proction relay for 11kv,640kw,f.l.a.-40a,1440rpm ht motor?
what will happen if ac and dc supplies given
What is the formula to calculate the rating of a three phase air circuit breaker
What are the no-load losses for the 11000/415V transformer with the following rated capacity? 1.1500 kVA 2. 2000 kVA 3. 2500 kVA 4. 3000 kVA
what is meant by directional earth fault and non directional earth fault? describe both.
What is a dc motor?
can u tell me the promotion from oiller to enginer
Why magnetic flux produces an induced current?? what is the detailed procedure ?? ans plz
why Y CONNECTION IS BETTER INTERMS OF EFFICIENCY AND P.F FOR A LAOD LESS THAN 40% AND WHY AFTER DELTA IS BETTER FOR > 40%
i am venkat i got gre 930(verbal 270 quanta 660) and my toefl score 105..here question is why u got less score in gre ? what i supposed to tell...any chance of rejection is there...my accadamics record is very good
sent to a site and asked to explain how you would like a twenty seven flour building should be supplied with lighting and sockets plus a water boiler.
I am designing new project sub station with 220 kV / 11 kV, 40 MVA capacity. This project have many recifier sets, which can generate 3rd harmonics. Now I have to select vector group of This transformer. To minimise 3rd harmonics, what care should I take in selection of Transformer Vecrtor group? If it is Y-Y with open Delta tertiary then what should be the rating & voltage of Tertiary Winding?
What do you mean by the zone of protection?
What is difference between Over Current & Earth Fault protection?
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
