Interested to Buy Any Domain ? << Click Here >> for more details...
I work on a electronic positioner transmitter 4211 at the
field.I connect my multimeter in series to get the current
output then I calibrate it to 4ma in 0% of position of the
valve and 20ma in 100% position of the valve.My problem is
in the field I get the correct output current based on my
multimeter but in the dcs they only receive 40% in a output
20ma of this positioner.Then I try to simulate in this
analog card and they receive the equivalent percent on the
value that I simulated.Is ther any possibility to reset the
zero and span of this positioner 4211 fisher.And what other
possibility I can do to fixed this.This is my email add (
landicho_randy@yahoo.com )
- 4 Answers
- 9500 Views
- I also Faced
- E-Mail Answers
Answer Posted / kaushik trivedi
dear friend as per my opinion be sure that your trasmitter
is 4 wire or 2 wire? OR ensure about your ai card 4wire or
2 wire
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how to check earthing,what is minum ohms for proper earthing
What pressure results for a flow transmitter of range 0- 180t/h in the dcs and 0-301mbar in the field using square root extraction. Kindly also suggest formulae for the percentages 0,25,50,75,100?
NPN transistor, SCR, Zener diode, LED, Varactor diode, Vortex meter, RTD, Resistor, Crystal
how to turbine speed measurement?
How vortex sensor used for steam flow measurment can be checked on line i.e without taking out from process line.
how to calibrate load cell
What is difference between differential pressure & delta pressure?
Give 2 application of quartz crystal used for process parameter measurement.
selection of the zener barrier for the hazardeous area zone 0
How can a d.p. Transmitter be calibrated?
key phaser where is use and work
please tell me what is a light up procedure of Cfbc boiler and what it's axuillaries of cfbc boiler?
To become an Instrument DESIGN engineer, is there any softwares or training to become Instrument Design engineer, plz suggest me, Iam very much interested in designing.
define feed forward control loop with example and drawing?
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
