Answer Posted / alok prabhu

Natural draught cooling towers use very tall concrete
chimneys to introduce air through the media.Due to large
size of these towers they are generally used for flow rates
above 45,000m^3/hr.These types are used only by utility
power stations.It is used where WET BULB TEMP is
low.Temperature difference achieved is 6-8deg C.

Induced draught/Mechanical draught cooling towers used
large fans to force air through circulating water.The water
falls downwards over fill surfaces which helps increase
contact time between water and air.cooling rate depends
upon fan diameter and speed of operation.It is used where
WBT is more.Used for critical applications.Temp difference
achieved can be 2-15deg C.When fan is switched off it works
as a natural draught cooling tower.

any one have amw(ASIAN MOTOR WORKS) QUESTION PAPERS OF PREVIOUS PLS SEND ME AT mahendra_yalavarthi@yahoo.com

3957

---

Explain why diesel engine is known as high torque and petrol engine as high speed engine?

1226

---

what are the main problems of solar electrical systems? to make quality control on, which parameters that need so?

2100

---

Maximum combustion temperature in gas turbines is of the order of 1100 to 10°c whereas same is around 00°c in i.c. Engine ? Why ?

1165

---

how to design a crankshaft?

2285

---

what is the difference between anf & centrifuge?

2955

---

have a clutchless car or bike clutch for power transmission???

2170

---

I need BHEL Engineer Trainee written test papers in Mechanical stream.

2343

---

How do you check steering gear

1932

---

How to calculate IKW (inputkilowatt) ie.. efficiency of a airconditioning chiller plant capacity of 310TR

2982

---

what is run out? how to calulate run out vaue.

1986

---

What are the different types of brakes?

1268

---

How to find the bearing dimension from its number for ex 24040

2208

---

how can i replace annular plats in tanks

2188

---

What is the difference between air conditioning and refrigeration?

1155

---