Interested to Buy Any Domain ? << Click Here >> for more details...
Can I use 1 phase power supply to run 3 phase motor? If yes, how?
- 6 Answers
- 7971 Views
- I also Faced
- E-Mail Answers
Answer Posted / navdeep
By using Capacitors we can convert 1-phase to 3-phase
| Is This Answer Correct ? | 7 Yes | 3 No |
Post New Answer View All Answers
Explain the operation of grid connected central solar inverter ?
Define conversion efficiency of a power amplifier.
what is the voltage between earth to neutral in lift.
what is the VA(Volt-amphere)? define with calculation?
What is Scheme Test of High Voltage Switchgear. Which tests it includes.
what is the meaning of 0.5ohm Resistance
In a 3 phase 4-wire system. For a 3.5 core cable if all loads are single phase and balanced, what will be neutral current? will it be sum of all phase currents? Or it will be zero? And if loads are unbalanced what will be neutral current?
If not into production, how far did you follow the design and why did not you see it into production?
What is the limitation of kirchoffs law?
why u r living from presentaly working.
Explain and give me an example of a time when you had to explain some new procedures to your co-workers for quality service delivery, how did you go about it?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
what is the correct method for the outdoor termination of 19/33 KV HT cable step by step?
How many capacitors using in LT panel as per Govt rules?
can i use the six sigma method which is used in management area, in state estimation of power systems?
