Interested to Buy Any Domain ? << Click Here >> for more details...
Can I use 1 phase power supply to run 3 phase motor? If yes, how?
- 6 Answers
- 7934 Views
- I also Faced
- E-Mail Answers
Answer Posted / muthuvel
No, 1 phase power supply can excite one winding only.But 3
Phase motor having 3 windings for that it Requires 3 Phase
supply...
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
How to calculate Number of Earthing Pits....???
can we choose current transformer secondary, to calculate residual flux in a power transformer, so as its saturation is close to the saturation level of power transformer?
i m in need of current rating chart of heavy duty pvc/xlpe, cu/al cables. can somebody provide me? if yes, plz send me at ashish_patel111@yahoo.com
How do we arrive at selecting reactive capacitance value as 30% of h.p rating of motor?
How many sprinklers should be in one pipe line?
How one may guess the direction from which the distribution line is incoming if there is no pole plate on poles?
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
Is there any type of starter for DC motor other than two point,Three point and Four point starters?
Whether power factor should be high or low? Why?
which IS or IEC is used for earthing,breakdown voltage of transformer oil, hv/pd testing and all type of electrical testing
when we decide to use soft starter drive or vfd drive in mcc to operate apump?
What is minimum phase system?
When we use 3 terminal resistor?
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
What is the rating of a circuit breaker needed for 300 kv load in 33KV supply line of 33/415 transformer ? Whether 800/1200 amp vaccum circuit breaker can perform for a 33 KV line in input in 415 volt in output of the transformer ?
