Interested to Buy Any Domain ? << Click Here >> for more details...
If we have 120 minutes run time method for HPLC and you wan
to decrease the Run time so what should you do??
- 6 Answers
- 13849 Views
- I also Faced
- E-Mail Answers
Answer Posted / pankaj shrivastava
There are some factors and parameters by which we can
decrease the run time as....
1. by increasing flow Rate
2. by increasing lightly Column oven temperature.
3. by increasing mobile phase strength.
3. by using short length column.
| Is This Answer Correct ? | 28 Yes | 3 No |
Post New Answer View All Answers
What are the primary considerations in extractables and Leachables ?
what is procedure of actual procedure for registration of drug?
Qc interview questions
Why only hydroxy naphthol blue indicator is used for standardisation of 0.05M EDTA solution instead of solochrome Black T or Euriochrome Black T indicator which is used for all sample analysis with 0.05M EDTA solution?
if your impurity coeluting with each other in that situation how require to set specification? is it acceptable?
HI,I CLEARED BOB CLERK EXAM. MY INTERVIEW WILL BE ON 9TH OCTOBER,2010.PLEASE SEND ME INTERVIEW QUESTIONS AND ANSWERS. THANK YOU.
what is the structure of DOWEX-50
can i use hplc detector to uplc and why?
WHY pKa value is more important than pH value of the mobile phase in HPLC?
why digestion require in icpms?
what is %labelled amount in content uniformity of dosage unit and its calculation?
Why use only methanol,used determinationof moisture content not use other solvents
In Assy by potentio metry titration method how select MET U ,DET U, SET U,
I have compare C2H2-air and C2H2-N2O flame AAS on determination calcium. Both use same range of std to plot calibration curve. (2-6ppm) When i measure the sample with phosphate, KCl and LaCl, C2H2-N2O flame give false positive result, around 0.5ppm. When i measure the sample with phosphste, KCl and EDTA. C2H2-N2O flame also give 0.5ppm false positive. But both above mentioned sample would not give false positive when measured by C2H2-air flame. What is the reason?
if tech transfer fails whay require to do?
