What is use of 3phase instead of single phase?
- 12 Answers
- 13726 Views
- DCM, L&T, I also Faced
- E-Mail Answers
Answer Posted / sunil parmar
if we can use 3 phase system losses will be reduced,cost will be reduced,load sharing will be equally,so voltage drop less and power quoality should be maintain in distribution and x' mission.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are the three constants associated with a steady state error?
Dear sir, How to calculate 3.5 core pvc aluminium armoured cable meter wise carrying amps rating.Please give the solution with a good example.
Why AC & DC capacitor are use in UPS ??????????????????
how mass curve differs from hydrograph.
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
how to identify conection leads of an unknown electric motor
do anyone out there know where to find a compleete list on acronyms/abbreviations used in offshore electric engineering. MCB - Micro Circuit Breaker, MCCB-Mouldes Case Circuit Breaker, ELCB-Earth Lekage Circuit Breaker, ELMCB- etc.....
What's the difference between non break power supply and non break non short break power supply
What is meant by harmonic distortion?
what are factors to be consider to design a HT & LT motor?
Why do we need interlocking in a HT metering or Ring main unit switchgear?
state basic meaning of 'INDUSTIAL AUTOMATION'?
specific difference of ICT&Auto Transformer
dg earth connect only in the amf panel or not why
