Interested to Buy Any Domain ? << Click Here >> for more details...
1-What is the difference between absorption factor and
polarization factor in insulation resistance test in
transformers?
and why we inject until ten minutes to get
polarization factor?
- 1 Answers
- 6476 Views
- I also Faced
- E-Mail Answers
Answer Posted / m.waqas(electrical)
both of the techniques are the same .
IN polarization index method the molecules of water are polarized and it takes almost ten mints to polarize the water molecule by using megger. This test is performed in field or you can say on used transformer or on that transformer which remain idle (not in use for long time with oil present in it) where there is a chance of moister presence due to condensation.
The dielectric absorption technique is used for type test(test perform after making transformer) here transformer is new and moister is just remove. As we all know absorption method is quicker than that of polarization(ratio of resistance measured 15 sec to 1 minit ).
BUT polarization technique is always preferred for good results or reliable results.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What are the basic components of the feedback control system?
how ct burden,magnetising current,ratio and knee point voltage are related & derived
what kind of quetions will ask in BHEL in interview? Plz help me?
In electrical locomotive engines, the DC series motors is being used as traction motor. But in new engines like in WAP7 & WAG9 the 3-phase squiral cage induction motors has replaced them. So can someone tell me the advantages of induction motor over dc seris motor in engines points of view....???
Can anybody just suggest about the scope of Electrical design with ETAP software?Just guide me?
What is the working principle of CFL & T5 tube light & 40W tube light with electronic ballast?
what happened when we supply a dc current in dc motor?? can it worked properly?
what is the difference between oil surge relay and buchholz relay.
I am inpecting a 10kVA UPS what tests should i do and should i observe?
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
How relay coordination has to be done? what are the inputs are required for this? Please explain this with calculation method?
why swinburnes test cannot be performed on series machines?explain
What is the meaning of floating point earthing in battery backed systems ?
What is pi controller?
What is inrush current?
