Interested to Buy Any Domain ? << Click Here >> for more details...
why is honed type flow orifice plate? what purpose it used?
how to select this?
- 4 Answers
- 17933 Views
- I also Faced
- E-Mail Answers
Answer Posted / sabry
Actually It's called "Honed meter run".
It's a 1 piece manufacturer piping assembly, used to hold the orifice.
It's called "Honed" as the piping internal surface is honed/machined to be glass smooth surface.
This assembly is very expensive & it's used in custody transfer applications.
REFERNCE"Lessons In Industrial Instrumentation"/Page:584,585.
Good Luck
Ahmed Sabry
I&C Senior Engineer
Cell:+2 (0122) 1367310
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
Calibration procedure for water rotameters
what is difference between HOT permit and cold permit
need to calculate flow rate with the help of dp range and orifice bore dia and size. range is 0 to 400 inwc and orifice size is 12 inch 150 # rf and bore dia is 7.180 inch. need to calculation for flow rate
How is work 5/2 sov?
How to calibrate capillary type level transmitter
Programmable Logic control.
What are different types of control valves?
The company where I am working, their is rosemount 5400 series radar type level transmitter, it is meant to show level of filled tank, but along with the level it is showing temperature also, so my question is how a onon-contact type radar type level transmitter can show temperature even if it does not have any contact with the fluid?
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
What is compensation for flow ? Why we use compensation ? What are the factors of different compensation ? We not use then what problems may happen ?
Why grounding is necessary? Give example with diagram.
How to check vortex flow meter is in good condition while we do not having calibration setup?
in differential pressure transmitter,min&max pressure range for hp&lp
how do u calibrate the vacuum transmitter if it shows more reading
