Interested to Buy Any Domain ? << Click Here >> for more details...
What are the protection used for alternator,transformers.
- 2 Answers
- 6622 Views
- Adani, I also Faced
- E-Mail Answers
Answer Posted / taju
For Alternator- Under/over voltage protection,Reverse
power,under/over frequency,ground fault protection,
For TXR-Buckholz rely,winding temperatur,Oil
temperature,ground fault protection.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Can clean earth cable be considered as low current cable
What is maximum power transfer theorem?
how to calculate the lightning arrester conductor @ no of earth pits required
A 100 kVA , 400 v/250 kv testing transformer has 8% leakage reactance and resistance on 100 KVA base . A cable has to be tested at 500 kv using the above transformer as a resonant transformer at 50 hz . if the charging current of the cable at 500 kv is 0.4 A find the series inductance required . Assume 2% resistance for the inductor to be used and the connecting leads . Neglect dielectric loss of hte cable . what will be the input voltage to the transformer ?
How to calculate Air conditioning capacity for a telecom BTS shelter?
Why transformer used in UPS??
Difference between a pilot wire and a normal conductor?
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
What if the difference beween internal and exrteranal LBB?
HOW TO TEST A LIGHTENING ARREST ER ?
In aerodynamic turbines which element is NOT there a.stator b.compressor c. Fuel intake system d.fans
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
What should be the values of settling time, peak time, steady state error, overshoot, rise time, MPOS (Maximum percent over shoot) to keep the system in transient state, to keep the system in steady state ?
What is difference between mcb and mccb.
how to select fuse rating for a 3-phase motor ???
