Transformer's core is made up of which material and why so?
- 10 Answers
- 29161 Views
- ABB, NTPC, I also Faced
- E-Mail Answers
Answer Posted / ashok mishra
it is made up of silicon steel stampings of approx. 3mm to reduse iron and core losses
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
How to calculate the multiplying factor for energy meter with ct ratio given
Why slip ring ind. motor power consumption is low compare to induction motor .same 90 kw motor used same load output
Is better to supply the voltage for static exciter from the auxiliary power source or from the SG terminals? And why?
What is highest size of HT motor like 11 kv or 33 kv,and how to make it 750 rpm.i think the size will be very big.any idea ? pl. reply..
What are IP protections used for electrical panels, JB, equipments installed in explosive zones like Petrochemicals, Oil & gas
what is calculation mathod/formaulla for deciding Size of busbar (Copper/ aluminum)for L.T. panel on Various Fault level like 50kA,25kA,10kA
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
what is inter connected dc generator?
Do you know what is dry-out test in x'mer
what happens when dc generator coupled with cycle shaft.also explain what happens when its loaded
What are the advantages of thermal power plant?
What is cut-off rate?
can you any one give exact mathematical relation between AC current and DC current?
what transformer we used normally and upto which kva?
can any tell me why slope 40% and 80% is calculated in differential protection?
