Interested to Buy Any Domain ? << Click Here >> for more details...
Why is starter necessary for a three-phase induction motor?
- 37 Answers
- 179462 Views
- BMM, Essar, Hero MotoCorp, ITI, Maruti Suzuki, Supertech, Watt, I also Faced
- E-Mail Answers
Answer Posted / pramitha
A reduced voltage is applied at the starting,and the
voltage is increased to the rated value,when the motor has
picked up speed.the reduced voltage is obtained by using a
starter.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
technically, what is the reason behind starting the motor star the delta connection .. and what other ways to do this rather than using " star-delta transformer"
How is the gain affected by the introduction of feedback in a control system.
1.why we are using metal oxide gapless block in lightning arrester,2.What is minimum and maximum rating of metal oxide blocks using in india
If a air condition consume 2.50 to 3.00 amp then how much it will consume in watts if it is running 10 hours out of 24 hours????
why wire sizes are 3/29 or 7/29 and why not wire sizes are 2/29 or 6/29?
Why efficiency in thermal power plant is low?
why the frequency and voltage in india is 230v and 50HZ. when compared to USA say 110v and 60 HZ.
As a electrical engineer.. what are the basic norms should follow in transformer oil testing.. 1.What is the Electrode type? 2.How long time you will give for oil testing?
in control panel, how can i measuring the distance between one bus bar to another bus bar. then now only for bus bar. in mpcb and contactor also. that means one mpcb to another mpcb how much distance? how can i calculate that.
when we have to use UPF wattmeter and LPF wattmeter? what is the difference between UPF and LPF wattmeter in terms of construction?
what's the difference between 'shaft power demand' and 'BHP' , when we consider electrical load list.
What is the formula for calculating no-load current?
what are the values of VRY,VYB,VBR,Vry,Vyb,Vbr,Vrn,Vyn,Vbn for Magenetic balance test of 100 KVA and 63 KVA Distribution transformer
how choose conductor&depending upon load
When calculating the speed of a rotor required for a particular frequency of synchronous generator we use the equation 60f/p Is this p is the number of pole pairs of rotor & do we consider the number of pole pairs in the stator is 1?
