Interested to Buy Any Domain ? << Click Here >> for more details...
what is meant by magnetic flow meter ? explain its working
principle ?
- 1 Answers
- 4682 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajesh
it consist of a turbine impeller mounted on a shaft which is
connected to a miniature dc motor . as fluid passes through
turbine , it rotates and velocity of fluid is proportional
to turbine speed . hence if we connect a voltmeter we get
flow reading . it is ideally a active transducer , but since
all fluids have different parameters a small voltage is
applied to turbine , but principle is same
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Explain cos(theta) and Sin(theta)
how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .
While HT line put on to activate ACB in low tention panel VCB tripping instantly.why it happens
what's producer of XLPE cable laying in undergroung
why is control bus bi-directional?
Difference between rating factor of cable and derating factor of cable?
HOW DO YOU CAN CHECK A 15KV DIODE, WHETHER IT IS OK OR NOT?
Motor,transformers,capacitor tubelight etc....
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
How to design harmonic filter at the project stage without nowing the harmonics levels
what is RNG in the DG synchronizing by PLC?
What is dynamo?How it works and what is the function of dynamo in a DG.
what happen if field of dc shunt motor opens? what is function of putting res. in parallel to one phase of 3 phase IM? the power supplied by 5A source in circuit is given by------Watt.
How to find ampere on ht side for selection of cable size ???
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
