Interested to Buy Any Domain ? << Click Here >> for more details...
What is GNR ? How much value of ground neutral resistance?
- 9 Answers
- 14799 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajesh
NGR stands for neutral
grounding resistor.it
depends on line voltage.if
line voltage is 11kv the
correspoding resistance
value is 63.5ohms.it's comes
from 11000/1.732
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
WHAT IS SPEC OF CLEANROOM MOTOR AND LIGHT FITTINGS?
Disadventage of cable-gland earthing if any ?
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
How to define Kirchhoff current law and voltage law along with simply examples.
What is the angle of inclination for the oil connection from transformer conservator to Bucholz relay and why?
What is resistance of 50meters, 16sq.mm, single core copper cable?
Please nybody say, weather the result of Bharat Oman is declared or not? Probable date of declare???????
Explain and give me an example of a time when you had to explain some new procedures to your co-workers for quality service delivery, how did you go about it?
If the Brush of DC motor is shifted by 90 deg, then what happens to voltage and torque? Both voltage and torque are zero. how to justify the answer?
In a voltage-controlled current source A A current booster is never used B The load is always floated C A stiff current source drives the load D The load current equals Isc
How to derive detailed design of Suitable bus Bar for 100A for 6.6KV?
Can i use the B-curve MCB instead of C-curve MCB
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
how define the torque in ac drive. from electrical side in the drive friquency ,voltage and current three factor is there.
For group 1 , 2 whather i have to prepare my technical or general studies etc? and im graduate in ee engg. for wht posts im eligible for? please tell me!
