Interested to Buy Any Domain ? << Click Here >> for more details...
What is the basic difference between 90% stator earth fault
and 100% stator earth fault, and its phenmenona?
- 4 Answers
- 19465 Views
- Reliance, I also Faced
- E-Mail Answers
Answer Posted / saka
90% Stator earth fault protection achieved through NGR and
100% Stator earth fault achieved through REF ( NGTR )
| Is This Answer Correct ? | 1 Yes | 6 No |
Post New Answer View All Answers
what will happen if synchronous machine rotor fed from single phase ac supply
What are the common sources of energy?
what is the benefit of floating our DC source? if i have two floating DC source of which 1 has a ref voltage of -21VDC and the other of -18VDC. can it be connected in parallel to share a common ref voltage? if not, how do i make both sources to be of common ref voltage? tks
if main CT is of ratio 50/5, and meter CT is -/5 what will be overall multiplying factor of meter.PT is 11000/110 .
why would amp draw on neutral wire be as much as amp draw on the hot leg.
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
how we findout a ignater is faulty or not?
What is load boxes ?
How to select a contactor? How many types of contactors are available
what is the question paper model for section engineer in RRB
What happens if we connect a single phase energy meter in reverse polarity.
WHAT IS IM (INDEX OF MOUNTING )IN MOTORS
WHY TERTIARY OF POWER TRANSFORMERS IS LOADED WITH EQUIPMENTS LIKE CT,PT,ISOLATOR AND CB
we have require a Motor (1500kW, 6.6kV, 50Hz) which shall operate at 1500rpm during 30min and after it shall run on 500rpm during 15min. The same cycle shall be repetitive during the whole working days. Which method is best and economic to achieve such type of task. VFD, VVFD, Pole changing motor etc.
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
