Interested to Buy Any Domain ? << Click Here >> for more details...
When we open the door of refrigerator then we feel hot,why?
- 3 Answers
- 11705 Views
- BARC, KPIT, Power Plant, I also Faced
- E-Mail Answers
Answer Posted / dr. t.s. ravikumar
When we open the door of the refrigerator in a closed room
initially the room may have some chillness due to exchange
of heat (less mass and low temperature refrigerated air
with more mass high temperature atmospheric air). After few
seconds, As the heat drawn from the room (when the door is
open) is rejected through the condenser in the rear side of
the refrigerator back into the room itself the temperature
of the room will not change. Though there is no useful heat
removal the compressor works continuously by absorbing
electrical energy which will be rejected as heat into the
room. Now it acts like an electrical heater. All high grade
electrical energy is converted into low grade heat energy
(first law). Thus the room becomes hot after some time.
| Is This Answer Correct ? | 45 Yes | 11 No |
Post New Answer View All Answers
What is ferrite?
what are the activities to be done after a steam turbine trips?
describe a type when u anticipated potential problems and development of preventive measure.
What are reasons for poor machinability for IS 2062 steel
What will be the cause of high temperature in one cylinder of D/E?
How can the reaction of support of a frame be evaluated?
engine so2 farmula
how to prepare welding procedure specification and pqr
please let me know the book for preparing to section engi and loco pilot bangalore
Is a diesel engines maximum rpm limited by the diesel burn rate?
Explain how can you convert air mass to air volume?
Assume a DC motor with the following parameters : Motor torque control = 0.0848 Nm/amperes Back EMF control = 0.0848 Volts/(rad/s) Armature resistance = 0.75 Moment of inertia = 0.00001696 kg/m2 With zero frictional load and taking a feed forward gain of 2, determine the motor response for a unit step function. please forwaded the answer to the below mail id thanks in advance Regrads, peer_kaba@yahoo.co.in
AFTER OVERHAULING KTA19G3 AND JUST ABOUT TO START ,BUT WE DIDNT FIX THE OIL SUMP AND TEST FOR -WATER LEAK FROM LINER O RING SIDE,THEN WE FILLED WATER AND FOUND WATER LEAK FROM INSIDE OF ENGINE -CAM FOLLOWER SIDE PLEASE GIVE ADVICE TO RECTIFY THE SAME
what is rolling margin?( from view of machining process ) explain briefly
ongc recruitment sample paper for asst.technician technical
