Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / n bala krishna
IF THE TANK LEVEL IS 0-100%, BUT IF YOU WANT TO MAINTAIN
30% AS THE MINIMUM LEVEL OF THE TANK. AFTER FILLING THE
TANK WITH 30% SOLUTION, I WILL PRESS ZERO TRIM. AFTER
PRESSING ZERO TRIM THE TANK WILL SHOW 30% LEVEL AS 0% IN
DCS.
| Is This Answer Correct ? | 14 Yes | 3 No |
Post New Answer View All Answers
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
what is the importance of CV in the control valves? how it is calculated?
What is the calibration procedure of Drum level transmitter if range is 0 to -400 mmh2o in lab?
why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V
What are advantages and disadvantage of the ac supply load cell?
How a conductivity sensor & analyzer work at boiler, whats the principle & science is beyond this,How conductivity sensor sence & convert signal & move toward analyzer & analyzer show reading in percent? also what is temperature compensate option in conductivity analyzer
How is flow measured in square root?
What is modbus?
anybody having Qatar Petroleum questions for instrument Technician offshore ....please send me
draw the block diagram of a level transmitter ?
what would be the minimum flow rate that we can measure on rotameter..?
Any one can help me to identified, how can we interchange the device in FF
If a control valve is hunting means means if we are giving 50% to the cv, the cv will open at 51% then slowly slwoly it will reaches 49% , so what to do for solve this problem. The cv is double acting and mounted for anti surge operation, it having 4 nos. volume booster, one sov, one positioner, etc..?
why orfice is not used for main steam flow calculation
Using your own examples solve a problem involving normal table. (experimental method and analysis)
