Interested to Buy Any Domain ? << Click Here >> for more details...
If an Instrument has 550 ohm internal resistance and the
cable used for that instrument is 0.5 ohm per meter
resistance. If the voltage is 12volt.How much length cable
can be used? Please tell me its Calculation formula.
- 5 Answers
- 9526 Views
- MOL, I also Faced
- E-Mail Answers
Answer Posted / praful
Mostly instruments are designed for 24v supply and 4to 20ma
output here we have 12v supply so resistance should be 125
ohms so we can make 550 ohms into 125 ohms by connecting
161ohms resistance in parallel for that we require 323mtr
cable.so we can use almost 300mtr cable. this is just my
practical assumption and i dont have any theoretical proof
for the same.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
why we take %i0.0 as input for twido plc
Capacitance, resistance ( colour coding ), parallel & series circuits.
what does the ratio 800-400-300-200/1-1-1-1-1 in the specification of current transformer indicates?
give me all the details about the interview and which type of question being asked
List three types Level Switches with their working principles
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
How many interlocks at turbine side?
How to decrease opening & closing time of on/off valve?
Linear amplifier.
Can anyone send most commonly asked interview question in Oil & Gas industry
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
we have a s-5 simense plc having op7 .recently on op7 showing error 1.plc not present 2. DB error frequently. can u have any solution . please send me.
Explain how thw analog to digital converter works with the circuit diagram
