how to can we synchronize different capacity of DG
sets.60kva& 250kva?
- 2 Answers
- 3999 Views
- Power Plant, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Synchronization is as usual.The load sharing depends upon
fuel feed to prime movers
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
how a.c. genarator control power factor when its conected to grid supply by incrising or decresing excitation voltage.
How we can calculate the life of Lead acid battery
why Y CONNECTION IS BETTER INTERMS OF EFFICIENCY AND P.F FOR A LAOD LESS THAN 40% AND WHY AFTER DELTA IS BETTER FOR > 40%
we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer
What shall be the secondary output voltage if the primary winding of a 220/6V, 50 Hz transformer is energized by an 110V, 60 Hz supply?
What is meant by a stray loss of a induction motor??? What is the equation to find it
How to calculate fault level of 11 KV system
tan delta equation test on alternators
why and how current drawn by battery charger depends upon the altitude where it is located?
what is Insulation monitoring device. where it is used? (in switchgear room or control panel or in field equipment)
Can we use BS 6651 and BS EN 62305 standards for computer room lightning ptotection in substation?
Why the symbol of register is "zig zag"
why ht cable end termination don't have a gland?
What the difference between three phase contactor (coil 110vac) & three phase SSR (control voltage 110Vac)? May I use contactor in place of SSR?
how to decide choke rating for drive?
