Interested to Buy Any Domain ? << Click Here >> for more details...
If any control valve create hunting problem, what is the
possible reason and solution?
- 6 Answers
- 20932 Views
- I also Faced
- E-Mail Answers
Answer Posted / dhaval joshi
First check actuator position..removed power from the
actuator...and accordingly connect first power supply
cable,after connect command and feedback cable.
| Is This Answer Correct ? | 1 Yes | 6 No |
Post New Answer View All Answers
Why even multiple power supplu r used in instrumentation system?
i have done DAE in Instrumentation and Process Control. i have applied for an apprentice training in chemical company after three day my interview will be conduct but i need more information about industrial process control and controller. my e mail is imran_dilsetu@yahoo.com please tell me interview question relative to instrumentation ?
can u plz send me technical questions asked in SCHNEIDER ELECTRICAL technical paper?
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
what is effect of specific gravity in differential level transmitter , explain formula related with this .
what is installation and commissioning of (fat & sat) of power plant dcs ? this question keeps in desirable conditions of one company .
how will you segregate the alarm levels in alarm management system during factory Acceptance Test
What is force balance principle?
WHAT IS TMXT IN TEMPERATURE FOUNDATION FIELDBUS.
What is the procedure of calibration of Load cell?
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
flow transmeter accuracy 0.075% of full scale & find ucertainty is 0.025 % so what is maximum limit band of uncertainty
all questions related to instrument technician in any offshore oil and gas company.
Name different parts of a pressure gauge.
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
