Interested to Buy Any Domain ? << Click Here >> for more details...
what is automatic voltage regulator and it is used?
- 28 Answers
- 58693 Views
- ACME, TCS, I also Faced
- E-Mail Answers
Answer Posted / ayid
its controlling device that maintain output terminal voltage
to the generator by excitation when the load connected.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the requirement regarding earthing of Single conductor with AWA
What is lc oscillator?
A ii kv 1200 A Breaker combination fixed in a cubicle. How many ampere Fuse is required? If fuse is not using, Why?
What is difference between Over Current & Earth Fault protection?
Dear Sir/Madam, I have one questions we have three steam turbines and one Gas turbine and our industry linked with the public network, we have protection system one of the protection is reverse power we can export just four MW only i would like to ask about how to calculate the reverse power. Thank you in advance best regards
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
tan delta equation test on alternators
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
how you configure motorvision relay (L&T make)from DCS
what is the best method of grounding in 30 MW generator?
what is the safety points of vaccum circuit breaker.
I have 2 KW electric water heater.I am gonna use it in controlling water temp.so I needed to increase or decrease the heating capacity.is there any electrical-electronic circuit for varying the resistance & so current?
What do you mean by pull of electromagnet?
Electrical 'C' license full abbreviation , and full form
How to synchronization will be done between two DGs ?
