Interested to Buy Any Domain ? << Click Here >> for more details...
how can findout cable fault Location only useing MEGGER
- 3 Answers
- 7334 Views
- I also Faced
- E-Mail Answers
Answer Posted / arun.kalady84
Using megger we can only find out cable is faulty or not .In the case of HV underground cables , for locating the fault we can use fault locating kit or prelocating kit . using fault locating kit we can pin pointing the fault location, Prelocating kit gives exact fault location im meters by calculation(above 50 mA leakage current is required for 132 KV cables)
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Draw a SLD for main panel for school having connected load of 1200kw and emergency generator 200kw.also show the increase of additional load of chiller 225kw in the lv panel indicating meter postion size of transformer ,cables and capacitor bank.
Which cable is use for rtcc control panel
how we arrange the hv side with delta connection in case 33/11kv of transformer.
How cable from Kit-Kat to main switch, from starter to motor are designed?
What are diffrent type of road taxes?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
lorteny method
How can we select suitable capacity generator for three phase load (inductive load) and how to take study analysis in 3 three phase load system ?
how to find the capacitance value of the motor while running??
can any one tell me about the Extra low voltage systems?From where we give supply to these type of systems??
I need bhel electrical test pattern & paper
what are the difference between PLC and embedded
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
how to calculate differential current when we testing differential relay..suppose we have 1000kw generator,630amp VCB,what value we should put /inject so that relay trip the VCB? PLLZ justify ur comment
What Is Sampling?
