Interested to Buy Any Domain ? << Click Here >> for more details...
I have two power supply.a)govt. power b)Captive power.3
phase load connected inside factory.when source change govt.
source to captive some motor rotate reverse. Is phase
sequence changes when if off & on?If I off generator & on it
again is it possible to get changed phase sequence??
- 4 Answers
- 6854 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / raj
yes its possibility to change phase sequence
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What will be the output voltage of a transformer if it is primarily energized from a square wave voltage source?
What are the functions of different probes used in cro?
What is the relation between frequency and motor rpm?
Which type of DG need Netral Earthing?
from where the self excitrd induction generator get the power?why is the voltage regulation is poor of seig?
Actually I have a doubt on neutral and earth.we use Ac power without taking neutral by connecting to earth,but at that time does it affects on efficiency of any electrical components or no? If yes how?
In MEP Services what are parts of STP and what are there function?
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
pls tel me the electric train traction motors name plate details like rpm,torue,voltage,amps,watts..ect..
What are the types of piano switches?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
slipring induction motor starting time Lrs operating why lrs starting time lrs outer body didn't get shock
HOW CAN WE DECIDE THE SUPPLY VOLTAGE FOR MOTOR ACCORDING TO ITS RATING(IF ANYONE KNOWS GIVE IT WITH EXAMPLE AND ITS CALCULATIONS)
If short circuit ratio is high is it bad or good for a machine then tell the reason...
Who are the manufactures those manufacturing 3Cx2.5sqmm FRLS cables. I heard about FRLS technology adopted only in wires useful for wirings
