Interested to Buy Any Domain ? << Click Here >> for more details...
Hi,
We facing one similar problem in our computers i.e we are
newly constructed our design department after that shifted
our computers but our computer desktop screen is vibrating.
we are conducted our electrical maintainance person he told
that is UPS problem, then we changed the UPS also again we
are facing that problem in that room only. then we put lcd
monitors that problem is solved. But in other monitors why
the computer desktop screen is vibrating please give a
suggestion to me.
Regards,
Raju.N.G
- 10 Answers
- 10716 Views
- I also Faced
- E-Mail Answers
Answer Posted / alihassan
dear actually the CRT does not working properly due internal
disturbances occurs inside the CRT such such as the fly back
transformer,electrons gun are weak or poor working
performances.so,i suggest you THAT replace LCD in place of
CRT.Because first your problem will solve 2ndly power saving.
Regards Engr;A.H.S
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
in Contactor opearation Why there is a difference in the values of the operate and release voltage in case AC supply
Bimetal strip used in overload relay what is that,which types of material used for that & percentage.
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
Explain with example of functional requirements of protection relay in terms reliability, selectivity, sensitivity
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
tell me some type of questions throught which i can prepare for exam and do my best
How can we calculate the efficiency of a Running (On-Load) Motor ? What parameters are required and what is the method ?
How to do cable earhing? whether by grounding Armour to ground or by running extra G.I wire along with cable? which one is preferred mostly amoung them? If the second one is more preferable how many GI wires to be run along with cable (1 or 2)?
What happens if we give the supply to the rotor of induction motor and make its terminal shorted?
What is quadrantal symmetry?
some basic standard questions on transformer.
Why is a plain induction motor unsuitable for wide speed control?
what is the formula for efficiency of francis turbine and generator for hydropower? what is best way to select francis turbine and generator?
Mention what are the different colors on wires indicates?
What is an order of a system.
