What is the gear mechanism of lathe machine?
- 6 Answers
- 16489 Views
- TATA, I also Faced
- E-Mail Answers
Answer Posted / ragu raam
Tumbler gear mechanism
| Is This Answer Correct ? | 39 Yes | 1 No |
Post New Answer View All Answers
can any one send me all the interview questions and test questions on strength of materials . to devarajk23@yahoo.com
Why gas turbine power plant needs efficient compressor ?
draw IRON-CARBON diagram.
Why is thick steel wire stronger than thin steel wire?
3x3x2.5 m room temperature increases by 20 deg cel in 24 hours by a lamp of 100 w. then tell the temperature of the filament
What is the name of solid solution of carbon in alpha iron and delta iron ?
Is there a lower limit to the gland surface finish for static O-rings, gaseous system? surface finish table lists 0.41-0.81 micro-meters for static gaseous systems. What is the drawback of using a smoother surface finish lower than 0.41?
Why PWHT IS NOT DONE TO STAINLESS STEEL MATERIAL?
What are the characteristics of Freon 12?
what is run out? how to calulate run out vaue.
Dear sir/madam, plz sand me techanical test question (mechanical)
What is add number
What are the requirements of a good fuel?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
i have an iterview on 18 sep for bhel ,pls send some questions asked during interview during the earlier interview on 11th sep
