What is a BBS?Find out the cutting length for a 300*300 column with 40 mm cover?
- 21 Answers
- 104731 Views
- L&T, SSC, I also Faced
- E-Mail Answers
Answer Posted / u.sulaiman
BBS is bar bending schedule.the ring size of 300*300 column
will be 300-2*40=220mm.for bending 75mm should be taken for
each of two ends.the total no of bends will be 5.if 8mm dia
bar is used then cutting length will be 4*220+2*75-
5*2*8=950mm
| Is This Answer Correct ? | 11 Yes | 6 No |
Post New Answer View All Answers
what are the changes in concrete pour height as per IS 456, 2009?
Why is concrete cube test carried out?
what is project?
A Cat excavator loader of 3Lm*3 heaped capacity bucket is to be used to load blasted rock directly into a crusher of capacity (consumption) of 100L
Can anyone tell me the sequence of the activities in a drawing room, kitchen & Toilet including civil work, finishing, electrical & plumbing fittings
what is the cost of rcc roof casting of 400 sq. ft. in kolkata
3. A vane 12.5 cm long, 8.8 cm dia was pressed into a soft clay at the bottom of borehole. Torque was applied and the value at failure was 55 N-m. find the shear strength of the clay on a horizontal plane.
5. Two long boundary walls run parallel to each other at a center to center distance of 1 meter apart. The width and height of the first wall are 0.30 m and 2.5m respectively. While those of the second are respectively 0.18m and 3.5m. Plot the distribution of vertical stress intensity due to walls on a horizontal plane, 1m below ground level. The walls have negligible depth of foundation and are made of brick masonry (y = 19.2 kN/m cu)
for Precast foundation howmany days required we can shift the foundation with american Standards i need reference with section any body can help
WAP to print 1) 1 1 1 1 1 1 1 1 1 1 2) 1 2 3 4 5 6 7 8 9 10
why the cracks occurs in NP3 class Hume Pipe ? And what is bearing capacity of it?
what is density of 20mm coarse aggregate.plz send answer my below adress e.mail
What is rate for brick masonry work of 1.0 m3 in cm 1:6?
What is the outturn of Ceiling plastering
What is command line?
