Interested to Buy Any Domain ? << Click Here >> for more details...
in our sub station why we step down firstly 33kv\11kv then
11kv to 430v. can we direct step down 33v to 430.v.
- 18 Answers
- 42900 Views
- Eaton, Siemens, I also Faced
- E-Mail Answers
Answer Posted / ramesh
Generally we can step up high voltage to low
or low voltage to high voltage for a possible range.
which is balance for our economical stage
but technically it is possible the turn ratio of the
transformer would be large and it will increase the size as
well also differs cost of the transformer.
so that generation for 11 kv increases up-to level ll 750kv
11kv-33kv-66kv--132kv---400kv--750kv
step down as 11kv-440V- 230V-110V
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
how can calculation ate Amps for cabel. Ex-for 1sqmm wire hou many amps we can draw
why Lightening Arrester Probe sharp at Top of telecom tower.
What is corkscrew rule?
Which capacitor is preferred for high voltage and frequency?
on a three-winding transformer relationship delta-delta-star, on third winding why the relationship is a star? what are the advantages and disadvantages? Thank you and please help
why servomotor motor? where i apply for best output?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
How to check the LM324 Ic
What is the function of attenuator in cro?
What is sensitivity of a measurement?
what r the checklist while installing 500 kva transformer
What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?
what is EIB lighting control system? what is the advantages of this system?
What is the temperature PROFILE OF A FLUID W. R. T. Distance from a sphere to which it is IN CONTACT which is at constant temp.?
what is active power & reactive power?
