Interested to Buy Any Domain ? << Click Here >> for more details...
what are the components of a start and stop motor control?
- 2 Answers
- 4059 Views
- I also Faced
- E-Mail Answers
Answer Posted / jayaram
suppose the motor is more than 5hp, two contractors,one
timer, two push buttons(no and nc)and one 230v relay is
required.because of star-delta starting.
but motor is below 5hp one over load relay,one contractor
and two push buttons(no and nc) is suffcient
| Is This Answer Correct ? | 4 Yes | 3 No |
Post New Answer View All Answers
how much GROUND & NEUTRAL VOLT maintain in data center.
why the field winding in dc motor is not short circuited eventhough dc supply is applied across the winding
WE HAVE THE DC RECTIFIER 1500A, INPUT VOLTAGE IS 3 PHASE. HOW TO CALICULATE THE LOAD? 3 PHASE SIDE EITHER dC SIDE. PLEASE SUGGEST ME
why you don not show protection and type of isolation in key single line diagram?
Electrical Engineering
what is Fault level? why it is calculated? how will u decide same for our plant?
hi i have applied for lic of india south cenrtal zonal ,hyd. i didnt get hall ticket till now.let me know how can i get form internet
what is electrical machines
An impedance of 100 ohms resistance and an unknown inductance is connected across the capacitor. The resulting impedance is a pure resistance of 500 ohms ifω = 10^5 rad/sec. calculate the values of inductor and capacitor.
why most of junction box vendors providing T5/T6 Temp class jb's for T3 area any special reason?
What is the previous name of Cox's Bazar
what is power factor ? how we can calculate the low power factor and amount of capacitor for improve that low factor ?
What is the classification of hydro projects based on installed capacity?
what is sevice settings for mccb?How can be it setted?
diff b/w normal grounding and resistance grounding
