why we step/down voltage in multipul of 11kv?
- 4 Answers
- 5149 Views
- Siemens, I also Faced
- E-Mail Answers
Answer Posted / sahil
this we do from the protection pt of view.
the insulators on the towers(ceramic disc type), their single unit is designed to protect from 11kv. this voltage is suitable according the mechanical and electrical constraints.
that's why on a 33kv tower you might see 3-5 discs of the insulator(discs never less than v to be protected from).
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what happen as when voltage drop(or may decrease) ? in case of atomic base theory?
how to find number of run cable laying[LT side] for transformer & alternator secondary side? [above condition for getting output power transformer to main panel side] give the example.
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
What’s electric traction?
WHAT IS DEAD END IN PROTECTION?
What are m circles?
Can anybody inform me about the pattern of ECIL GET( Graduate Engineers Trainee) interview for Electrical students? Will there be HR round as well? I thought of preparing for 2 to 3 subjects thoroughly. Will it be sufficient? Please share your thoughts.
UG cable sizes were specified in sqmm. But practically its not coming to mesure. What's the reason for that? And how they specify the size of the cable?
HOE WE CAN IMPROOVE BY USE OF CAPACITOR
what is the function of capacitor duty contactor in an capacitor panel???
what is allowable ac mixing in dc
what is differnce btwen lll and lllg faults
how we select ac fuse rating of an power inverter???
a starter used for squirrel cage induction motor?
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
