Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ghani
It is defined by BS standards and now being included in IEC
as well. The accuracy limit factor in class X is defined by
manufacture with details of Knee point voltage limit, CT
resistance. So the X class mostly being used for
differential protection and also can be used for metering
purpose.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
what are the major & minor faults that occur in an inverter and in UPS ? And how to repair and resolve them ?
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
what is circuit breaker in transfomer and where it used
I NEED RRB SYLABUS FOR JE ELECTRICAL ,PLEASE SEND TO MY E- MAIL ID joo28_eee@yahoo.co.in
What is UPS and How do you maintain the UPS Maintenance? Brief Description on UPS maintenance.
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
please send previous exams question papers
what is harmonics? what are the factors it will depend upon
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
What if high voltage side circuit breaker of a ehv transformer instead of lvcb? Kindly elaborate.
Why the efficiency of generator is more than motor in swinburne's test
what will happen if i connect 12 volt battery with 24 volt battery charger.
What happened ,If 3 phase clearance not maintained in 33KV Line,11KV LIne etc?
what is mean by transition resistance of transformer?
Can any one know what are the symbols at the down (below) the analog ammeter??? there are 4 symbols which are they ?????
