Interested to Buy Any Domain ? << Click Here >> for more details...
I am having a DG set.The 415 V from Generator is step up to
460 v and then the same is used for Induction furnace.
before Step up, I am connecting LT load to my factory use.
When Induction furnace is in service from DG, when i try to
start a motor, the generator is tripped.Please tell me the
reason.
- 3 Answers
- 5503 Views
- I also Faced
- E-Mail Answers
Answer Posted / asif.k64@hotmail.com
Also check if the motor starter is working properly and APFC
panel is off while generator starts, check the fault codes
on the breaker if you have an ACB connected in the AMF panel.
Though there could be many other reasons as well but I would
rather check these things as well.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
can you please send me the technical questions and aptitude questions of honeywell and jindal steel electrical engg. question paper my e-mail ID is(kkesavanraj@gmail.com)
Direction of flow of active power and reactive power with logic?
Refernce currents are to be generated using refernce cueernts how can this be done??
What is resonant frequency?
what is meant by loss of field in a DC motor? how a universal motor works?
number of I/O devices in siemense plc
we have 3.5MVA-11/6KV transformer. how can we calculate earth fault current and NGR calculation?
How much current will a 5 HP delta connected motor at no load will take?Is tat need a starter
what is excitation/
Draw the vector diagramme for Asynchronous Induction Generator at noload,half load and fullload.
What are the causes of unbalanced current on 34.5kv feeder Ia=0.05,Ib= 0.25, Ic=0.15 and In=0.27 prior to tripping current are balance?
what is the Transformer Impedence?How can calculate?
Why hydropower stations are preferred solution for meeting peak loads in grids?
what is the difference between changer, converter and transformer?
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
