Which one is the Best protocol- Static routing,
RIPV2,EIGRP,OSPF.
Answer Posted / niraj mishra
Hello friends,
I will say that its depend on your topology, because network
administrator configure routing protocol on the based of his
topology.
Say if you have back to back connection then STATIC is
best,due to less of AD value. It has 1/0 of AD value
But when we will talk about middle organization then we can
say that RIPV1/V2 is best because it has features to work on
different subnet mask, and Trigger update where in static if
any change occur than it will be tough to configure in each
and every router. RIP is based on only for 15 maximum host.
It has 120 of AD value
okay now EIGRP is the best if you are using many routers of
same vendors because it work on DUAL method, means it never
count hop it work on Bandwidth, metric, etc. which has 90 of
Ad value
and OSFF is best when you are using different vendor router
because EIGRP work only on cisco router. so that time OSPF
would be best. which has 110 of AD value.
Someone will says that less AD value protocol is best, but
I'll say that its only to put priority to
different-different routing protocol.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What’s the simplest way to remotely configure a router?
How many types of ethernet?
What is the minimum and maximum request timer?
Can yo define LNS
What is the minimum request timer?
Mention the ranges for the private IP?
Explain the term 'unicast'.
Which type of routing you did in ccna?
What we called 64 bit mac-address in ipv6?
What is the default bandwidth size of t1 routers?
Why is UDP lease favored when compared to TCP?
After how long eigrp protocol advertise its routing table?
What is trigger rip and from which ios version it starts?
What are the disadvantages of symmetric algorithms?
Explain the difference between tracert and traceroute?