Interested to Buy Any Domain ? << Click Here >> for more details...
why we use 110vac in overhead crains? why not 220v, 24v
- 3 Answers
- 6800 Views
- SOFT, I also Faced
- E-Mail Answers
Answer Posted / ravi
for same body resistance the high voltage causes high
currents to flow through the body. for ex body resistance is
20kohm(generally).220v gives 11ma.for 110v it is 505ma,
below the danger value. if it incase not not grounded
properly it may helpful to limit the shocking current
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is the suitable transmission voltage?
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
IN SINGLE PH TRANSFORMER IF LEKAGE IMPEDANCE DROP IS NEGLECTED ,THE FLUX IN THE MAGNETIC CORE and the lekage flux linking a winding are a)proportional to the applied v to the winding i respectively.
how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?
Why we use ups battery and dsdb battery in thermal power plant
how to calculate singlephase motor efficiency?
What is synchro?
in basic 2 phase will short means tripping the power but spot welding 2 phase shorting but not tripping it will welded why.....(Q)
Does all the output contacts (N/O as well as N/C) of a Numerical relay operate when relay receives a binary input/inputs or contacts are designated to specific logic input/inputs and only these contacts operate?
delta motor winding resistance I take normally single winding is 2.5, which value is came delta connection ie RY ?
Details about Flux Compensated magnetic Amplifer starter for motors
What is ferro-resonance in electrical system? Why it occurs and what are measures to prevent it?
The gauge indicates the number of amps, but what about voltage? How voltage rating (for wire or fuse) determined?
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
can i use 4 number of circuit breaker as single phase manual change over switch? if yes then how plz also send ckt diagram at nazimzamurad@gmail.com
