Answer Posted / srinivasa chary

-> In case of electrical engineering, it is related to
generation and transfer of power.

->In case of electronics enineering,it is related to
control of that power by taking small amount of power.


we can compare these as like, suppose for a motor it
is taking the power to run but how much of power or current
to take for working properly is desided by electronics..

How LT megger works ?

2173

---

a starter used for squirrel cage induction motor?

1734

---

What is synchro?

1228

---

What is the complete procedure of erection of electrical panel in industry

1921

---

Define steady state error.

1139

---

can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?

2093

---

If symmetrical fault occurs at the terminal of a synchronous motor then how the motor will act...explain it..

2201

---

what is the ckt diagram of a tubelight and is it the simplest ckt of electrical engineering and also the component?

2430

---

Distribution transformer we provided 2 separate earthing pit for Body and 2 separate earthing pit for neutral,we can not connect separate body earthing pit to other earthing pit but we do metal glanding in secondary side cable termination in both side, transformer and PCC panel (LT Panel), is this safe for transformer and other equipment?

1771

---

what is the use of sdf?

2157

---

which mm cable should be used for 1.hp immersible pump motor for the distance of 330 metres?

1747

---

How many types of electrical earthing are there?

1261

---

Haw to check conductivity of budbar

1854

---

What is the use for cable entry in control room?

1202

---

in parallel operation of power transformer why the distance between power transformer and capacitor bank feeder is necessary to know

1853

---