Interested to Buy Any Domain ? << Click Here >> for more details...
which trsanmission is easy and cost effective AC or DC.
- 19 Answers
- 20170 Views
- I also Faced
- E-Mail Answers
Answer Posted / ifeanyi orakwe
Both forms of electricity have their specific applications,
and have their own advantages as well. However in terms of
transmission generally, I think AC is better; since we can
transform the voltage levels, we can minimize losses in
transmission, thereby maintaining good transmission
efficiency generally.
I do not think it is easy changing the voltage levels of a
DC system, except for the use of potentiometers, which
enable losses on the DC network.
Or do you know of any other means of changing the voltage
levels of the DC network?
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
where is the need for short circuit test for 3 see is required and why? can you explain in brief with application
Is there any question in the name of Static Switch in UPS??
How earthing of switchgear system to be done.
why we need to us lenz's law for synchornous motor
what is the acceptable value of TAN DELTA and dissipation factor for 11kV, 1.75HP Motor?.
what is kvarh? Please define it With calculation General motors ?
8. A DYNAMOMETER TYPE WATTMETER RESPONDS TO THE.......
what would u consider to be the basic purchase order information you would need to proceed with a cable inspection assignment?
what is the need of starter in tube light and what type of starter is used in that?
what's the difference between 'shaft power demand' and 'BHP' , when we consider electrical load list.
Hi I'm doing my MBA(3rd semester).I applied for the post of ET conducted by BHEL the last year.I cleared the written and lost in personal interview.Again I wrote the exam this time and cleared the written n yet to take the personal interview.Shall I disclose in the interview about my studies.What shall i say if they ask about my change from studies to job
what is meant by brushed alternator & its working principle ?
why should the primary of transformer be connected in delta in a heat run test?
how the aircraft outer body and inner body is separated ?
What is cross over distortion? How it can be eliminated?
